Setup CCcam On Eaglebox HD 800


The syntax for the line is: {c, port number,, username, password}.

First you must activate Super Setting where all the good stuff is by the following:

Menu -> Setting -> Version

When the cursor is on the Version option, press the red button, enter the PIN 1510 [the same process will disable Super Setting, if it is enabled].

Select Super Setting – press OK.

The first option allows you to select a C/S option – CCcam NewCamd – Avatar -ECam or Disable.

Avatar and eCam have no function in the Europe.

As each C/S option is selected, the relevant Config option appears highlighted. You may enter there and add your line details.

To view what is there, and unhide the data, press the red button and enter the PIN 7878.

To check if all is OK, use the test option at the bottom of the Config sub-menu. It will attempt to connect, and give you a “Success” or “Failure” result.

The other option in Super Setting is EMU. Use this if you have loaded a Softcam. Its use is obvious and needs no explanation. To load super setting details:

Edit the attached txt file to add the details you have been given;

Copy it to a USB stick;

Insert it in your Eaglebox HDMenu – Setting – Upgrade – USB/Card Upgrade – /udska1;

Select the file;

Press OK and wait.

The receiver will reboot.

Leave a Reply

Your email address will not be published. Required fields are marked *